Brand New ML-859 ESD Desoldering Station

Description:

This is a brand new, ML-859 ESD Desoldering Station. Temp-controlled desoldering station is composed of; air pump part, heating part, transfer part, and control part. Air pump part is including diaphragm pump, high power electro motor. Heating part is ceramic heater (temperature sensor) & desoldering tip. Transfer part is made up of a desoldering gun, vacuum pippette and filter gauge. Control part is control PCB. While working, the electromotor drives air pump and make negative pressure to imbibe melted soldering tin into filter pipe, thereby it gets the goal of suctioning out soldering tin on the circuit board.

Features:

 

• Anti-static design, to prevent from break caused by static and creepage.
• Powerful built-in vacuum pump, doesn't require to connect another vacuum system. Very convenient to put and use.
• Heating system is adopted sensor that is closed loop temperature control to ensure precision and constant temperature.
  
• Transfomer make the power from main power supply into 26V AC low voltage for the heating element, good for safety in work.
• High quality Hot-resistance soft vacuum tube, to avoid damage by hot desoldering gun.
  
• Electromotor of vacuum pump is fit on temperature safety resistance, prevent it from damage due to long time working.
  

Specification:

Voltage of Power Supply	110±10%V AC 60Hz
Heating Power	60W/27 ±10% AC 60Hz
Temperature of Desoldering tip	280oC-450oC
Pump	Diaphragm
Vacuum Suction	-680mmHg
Tip to Ground Resistance	Less than 2Ω
Electromotor Power	40W/ 110V AC
Tip to Ground Potential	Less than 2mV
Dimension	105X250X165mm
Weight	About 4kg w/ iron holder and power cord

Packing List:

• ML-859 Desoldering Station
• Accessories to ML-859 (4 desoldering tip, cleaning rod, filter, etc.)
  
• Soldering Stand
  
• Opertaional Manual
• Power Cord